Ingredients:

  • 1 Magazine File (cardboard or plastic)
  • Decorative Paper or Fabric
  • Craft Glue or Mod Podge
  • Scissors or Craft Knife
  • Ruler or Measuring Tape
  • Pencil
  • Optional: Embellishments (Ribbon, buttons, stickers, paint, etc.)

Instructions:

  1. Prep the File: Lightly sand the magazine file if it has any rough edges. Wipe clean.
  2. Measure and Cut: Measure the exterior surfaces of the magazine file. Cut the decorative paper/fabric slightly larger than each measured piece (allowing for overlap).
  3. Apply Glue: Apply a thin, even layer of glue to one section of the magazine file.
  4. Attach Covering: Carefully position and smooth the paper/fabric onto the glued surface, working from the center outwards to eliminate air bubbles.
  5. Repeat: Repeat steps 3 & 4 for each exterior surface of the magazine file, overlapping edges neatly.
  6. Trim Excess: Once the glue is dry, trim any excess paper/fabric using scissors or a craft knife.
  7. Seal (Optional): If using Mod Podge, apply a thin coat over the entire surface to seal and protect the paper/fabric.
  8. Embellish (Optional): Add any desired embellishments (ribbon, buttons, stickers, etc.) once the glue is fully dry.
  9. Dry Completely: Allow the finished file to dry completely before using.